david brown clutch adjustment

Answer 1

Hi   Are you sure the three side adjusters are set correctly there should only be a 25,000 thou gap between the bottom of allen skrews and top of pressure plate, once you press the levers it lifts the pressure plate first clearing main drive then hits the allen screws and that fits the intermediate plate away from pto drive at this point both drives should be clear.

I am a  tractor clutch manufacturer see   www.tractorclutch.co.uk

Regards Ray

Answer 2

I have a 990 The clutch finfers are too far away from the throw out bearing not allowing enough travel to disengage the pto clutch. What do I need to do?